More information about the Sublimable Frosted Glass Clock Photo Panels

INDEX

> Description

> Things to keep in mind

> Clock assembly

> Measurements

> Recommended sublimation instructions and parameters

DESCRIPTION

• Frosted glass photo panels with sublimable white polyester back
• The sublimated design will be visible from the front with a certain volume effect
• Central hole of Ø10 mm to install a clock mechanism
• Clock mechanisms with plastic hands. Require 1 AA / 1.5 V battery (not included). Available in Related Products
• White plastic stands with decorative diamond for tabletop. The rectangular also includes 2 screw caps with diamond
• The square photo panel has a single hole for the stand. The rectangular one has one in each corner for horizontal or vertical placement
  
• Comes in a white presentation box with a window

THINGS TO KEEP IN MIND

• You can purchase other mechanisms with different clock hand models in Related Products
• Sublimate on the reverse side, the white face, in direct mode (not mirrored)

CLOCK ASSEMBLY

• Insert the clock mechanism spindle through the stand and the previously sublimated panel
• Screw the hex nut onto the spindle and tighten it firmly
• Place the hour hand at the 12 o'clock position and press it gently
• Repeat the same process for the minute hand and finally for the second hand

MEASUREMENTS

Clock mechanisms with hands

(*) The minute hand is measured by the circular path it travels and its width.

(**) The length of the hands is measured from the centre of the hole to the tip.

RECOMMENDED SUBLIMATION INSTRUCTIONS AND PARAMETERS

Parameters indicated are for guidance only. It is recommended to conduct preliminary tests to make necessary adjustments before starting production.

WITH FLAT TRANSFER PRESS - DIRECT METHOD

• Print the design in direct mode
• Heat the press to 180 °C
• Secure the printed paper onto the white side of the photo panel with heat tape
• Place the photo panel and paper with the sublimable side facing up on the press plate
• Place the silicone pad over the photo panel for even pressing (optional)
• Close the press with medium pressure for 80-90 seconds
• Using a protective glove, remove the freshly printed photo panel
• Carefully remove the paper

WITH FLAT TRANSFER PRESS - INDIRECT METHOD

• Print the design in direct mode
• Heat the press to 200 °C
• Place the Nomex pad on the lower plate of the press for even heat distribution
• Secure the printed paper onto the white side of the photo panel with heat tape
• Place the photo panel and paper with the sublimable side facing down on the press plate
• Close the press with medium pressure for 240 seconds
• Using a protective glove, remove the freshly printed photo panel
• Carefully remove the paper