More information about the We R Memory Keepers Foil Quill magnetic mat

• Holds the foil during the transfer process with the help of the magnet strips. No need to use adhesive tape.
• Suitable for hot and cold foil.
• Includes 4 magnet strips: 2 long and 2 short.
• Works with the following cutting machines: Cricut Maker, Cricut Explore Air 2, Silhouette Cameo 3, Sizzix Eclips 2 and Brother Scan-N-Cut (DX y SDX125).
• Delivered in a blister pack with a hole you can hang on a display stand.

THINGS TO KEEP IN MIND

• Make sure to remove all blades from the plotter before using the mat to avoid any damage.

TIPS & TRICKS

• Cut the material before foiling it or work with pre-cut pieces.
• Use documents with crop marks, print, apply the foil and cut using your usual cutting machine.
• Use the Pixscan mat to cut the material and then do the foiling. You will find it in Related Products.

DIMENSIONS (APPROX.)

RECOMMENDATIONS FOR USE WITH VINYL CUTTER

• Remove all blades from the machine cartridge.
• Place the side magnetic strips 2.5-5 cm from the top edge of the mat. This avoids hindering the carriage.
• Place the long strips on the sides and the short strips at the bottom of the project.
• The material and the foil should be 1 mm thick to prevent jams.
• Level the mat to the height of the machine so that it fits smoothly.

INSTRUCTIONS FOR USE WITH VINYL CUTTER

1. Align and adhere the mat to the cutting mat’s grid you normally use. The grids should be the same size.
2. Place the material on the magnetic blanket using the grid to align.
3. Place the foil sheet on top of the material and hold it with the magnet strips. Leave the top side without magnet strips so as not to hinder the machine carriage during foiling.
4. Adjust the rollers by sliding them sideways. Not for all vinyl cutters.
5. Load the magnetic mat from the machine interface.