Starting at: €4.76 / Each Unit

Sublimation Square Wooden Clock


Square wooden table clock, printable by dye sublimation printing and laser engraving.

  • Wood MDF of high quality
  • Powered by 1 battery AA (not included)
  • Print area. 12.7 x 12.7 cm

More information

Immediate: 70 units
€5.95 VAT not included / Each Unit
VAT not included
  • Buy 2 for €5.36 each
  • Buy 5 for €5.06 each
  • Buy 25 for €4.76 each
Reward Points
As a Premium Brildor Member, for each unit you buy, you will accumulate {{POINTS}} to redeem on your next order. Discover the Brildor Loyalty Program. For each unit you buy, you will accumulate {{POINTS}} to redeem on your next order. Discover the Brildor Loyalty Program.

More information about the Sublimation Square Wooden Clock



> Description

> Things to keep in mind

> Dimensions

> Recommended instructions and parameters for sublimation printing




  • Includes support to place the clock envelope flat surfaces black metal hour and minute hands, and the mechanism for its operation
  • Sublimatable face white gloss. Black back of the board
  • Base or square-shaped board and rounded edges
  • Made of wood fibres bonded with synthetic resins by pressure and heat, until it reaches a medium density. Also known as MDF wood MDF or Trupan
  • Operates on 1 battery AA/1.5V which must be purchased separately. In the Related Products you will find the right batteries




  • The board of the clock board is covered with a film clear plastic that protects the face of the printable. It must be removed before sublimation
  • It is recommended to pre-iron the board at 200°C for 15-20 seconds. This will remove any residue that may have been absorbed by the humidity wood that may have been absorbed by the wood. In this way, the board will not flake or crack




Clock (cm) 12.7 x 12.7 x 5.8
Thickness (mm) 3
Print area (cm) 12.7 x 12.7
Support (cm) 6.1 x 10.5 x 5.5
Weight (g) 128




Parameters given for guidance only. It is recommended to carry out preliminary tests in order to make the necessary adjustments before starting production.

  • Print the design in mode mirror
  • Preheat the press to 200 ºC
  • Place the board of the clock on the base of the press and the printed part of the paper on the board
  • Close the press at medium pressure for 40-45 seconds
  • With the help of a protective glove, remove the freshly printed board
  • Carefully peel off the paper
  • Mount the mechanism with the needles and you are ready to hang it up
More Information
Ref. 036842
Net Weight (kg) 0.102
Gross Weight (kg) 0.128
Billable Weight (kg) 0.0500
Surface material Wood
Items Clocks
Accessory details Mechanism with hands, Holder
Marking techniques Dye sublimation, Laser engraving
Write Your Own Review
Post your question