More information about the metallic DTF film

INDEX

> Description

> Things to keep in mind

> Application instructions

> Washing recommendations

> Technical data

> Technical sheet

> Related posts

DESCRIPTION

• Allows you to print designs with defined details in one colour with a mirror effect
• Anti-static PET film with anti-sublimation properties
• Slightly porous printable side, white colour. It absorbs the ink, keeping it wet so that the DTF powder adheres easily. Additionally, it prevents the ink from migrating or spreading
• You can prepare the transfer to be applied to the textile immediately or for later applications
• Complies with Oeko-Tex Standard 100 category I, certifying that the raw materials used are eco-friendly, free of PVC, plasticisers, and heavy metals

THINGS TO KEEP IN MIND

• The design is printed only with white ink
• If you mistakenly print on the wrong side, you can remove the ink from the film using a piece of kitchen paper or a napkin; the ink will not adhere
• It is recommended to store in a cool, dry place, protected from direct sunlight

APPLICATION INSTRUCTIONS

Parameters indicated as guidelines. It is recommended to perform preliminary tests to make necessary adjustments before starting production.

• Print the design in mirror mode on the white side using only white ink
• Apply the DTF powder over the ink, covering it completely. Ensure that no powder residue is left on any part of the sheet other than the design. This will prevent unwanted parts of the sheet from transferring to the textile
• Cure the ink:
  • For immediate applications: cure the design at 165 ºC for 2 minutes
  • For later applications: cure the powder at 190 ºC for 8-10 minutes
• Press your design onto the textile, with the metallic side facing up. Protect the heat plate and the base plate with protective paper:
  • 160 ºC for 20-30 seconds
• Peel the film cold. The powder will act as an adhesive on the textile, so you should peel the film firmly
• If there are rough edges on the metallic film, remove the excess with low-adhesion tape

WASHING RECOMMENDATIONS

• Wash in cold water, at a maximum temperature of 30 °C
• Short washing cycles

TECHNICAL DATA

TECHNICAL SHEET

Metallic DTF film technical sheet (.pdf - 0.34 MB)

RELATED POSTS

How to make metallic prints on t-shirts