More information about the 20mm Sublimable Acrylic Photo Panels

INDEX

> Description

> Things to keep in mind

> Measurements

> Recommended sublimation instructions and parameters

DESCRIPTION

• Suggested uses: general photos or portraits, awards or trophies, commemorative plaques, signage, etc.
• Thanks to their thickness, they are stable and can stand on their own on flat surfaces, without the need for supports
• The sublimated image is visible through the photo panel as if it had depth, creating a three-dimensional effect
• The entire white reverse side, right up to the edge, is the printable area
• Supplied in a white cardboard box

THINGS TO KEEP IN MIND

• It is recommended to personalise the photo panels using vertical transfer presses. This will ensure even transfers across the entire surface
• Sublimate on the white side, in direct mode (not mirrored)
• Both the white sublimable side and the transparent side are protected by a plastic film that must be removed before sublimation

MEASUREMENTS

RECOMMENDED SUBLIMATION INSTRUCTIONS AND PARAMETERS

Indicative parameters, which may vary depending on the initial temperature of the material or the model of the press. It is recommended to carry out preliminary tests to adjust them if necessary.

• Print the design in direct mode (not mirrored)
• Heat the press to 200 ºC
• Place the printed paper (face up) on the base of the press
• Place the acrylic sheet on top of the paper with the white side facing the print
• Secure it with heat-resistant tape
• Turn the photo panel over so the attached paper faces the heating plate. Cover it with protective paper
• Set the press to medium-low pressure and 200 seconds
• Once finished, carefully remove the paper using a protective glove