The store will not work correctly in the case when cookies are disabled.
The legal stuff about cookies:
This message requires us to tell you about our cookie policy. If you continue browsing, we'll assume you accept it and think it's okay.
Don't worry, this message only comes up once.
Sublimation Stainless Steel Water Bottle - Gradient Effect - 500ml
Share
Sublimation Stainless Steel Water Bottle - Gradient Effect - 500ml
500ml bowling bottles in Orca quality lacquered stainless steel you can personalise with dye sublimation printing. Double walled flask to keep drinks hot or cold.
Suitable for personalising with a heat press machine using 6-9 oz mug heaters. Also with a sublimation oven using clamps, heat shrink bags or silicone sheets
THINGS TO KEEP IN MIND
Orca certification sticker on the base. Easily removable if desired
DIMENSIONS (APPROX.)
Capacity (oz/ml)
17 / 500
Thermos flask (cm)
Ø7 x 26.5
Cap (cm)
4 x 5
Body (cm)
Ø7 x 26.5
Full print area (cm)
22.5 x 24
Weight (g)
304
RECOMMENDED INSTRUCTIONS AND PARAMETERS FOR SUBLIMATION PRINTING
WITH A MUG HEAT PRESS
Print the design in mirror image
Preheat the press to 180-200ºC
Remove the lid from the bottle
Hold the paper's printed side against the bottle and fix it with heat-resistant tape
Place the bottle inside the press
Press for 35 seconds, medium pressure
Remove the newly printed water bottle using a protective glove
Carefully peel off the paper
WITH A SUBLIMATION OVEN
Print the design in mirror image
Preheat the oven to 200ºC
Remove the lid from the bottle
Hold the paper's printed side against the bottle and fix it with heat-resistant tape
Place and adjust the wrap around it or slide the bottle into a heat shrink bag and create a vacuum with a heat gun. You can also use a silicone sheet
Sublimate in the oven for 6-7 minutes
Remove the newly printed water bottle using a protective glove