More information about the Sublimable  Glass Photo Panel 10x15 & Rocker

INDEX

> Description

> Things to keep in mind

> Dimensions

> Recommended instructions and parameters for sublimation printing

DESCRIPTION

• Photopanel that manages to give the printed photo, 3D effect
• High quality with layer from polyester on the back suitable for sublimation
• The printable side of the photo panel is white colour, while the other is clear
• Rocker of clear plastic with an arched shape base or support
• The photo frames is easy to assemble: just fit the panel into the grooves of the rocker arm.
• It comes in a box from white cardboard

THINGS TO KEEP IN MIND

• The rocker is not sublimable

DIMENSIONS

RECOMMENDED INSTRUCTIONS AND PARAMETERS FOR SUBLIMATION PRINTING

Parameters given for guidance only. It is recommended to carry out preliminary tests in order to make the necessary adjustments before starting production.

• Print the design in direct mode (no mirror)
• Preheat the press to 200 ºC
• To properly sublimate this product you must use a Nomex pad (you will find it in Related Products)
• Place the Nomex pad in the lower platen of the press
• Place the printed paper in contact with the back side of the photo frames and stick the paper with heat tape, placing them on the press so that the printable side is underneath
• Close the press at medium-high pressure for 240 seconds
• With the help of a protective glove, remove the photo frames from printed
• Carefully peel off the paper