More information about Sublimable RFID 7x10 Card Holder Wallets

INDEX

> Description

> Things to keep in mind

> Dimensions

> Recommended instructions and parameters for sublimation printing

DESCRIPTION

• Card holder with RFID blocking system that prevents unauthorised electronic use of credit cards
• Security device that prevents cards from sliding out of the holder, even if it only contains 1 card
• Magnetic clip closure
• Side button to automatically remove cards by unfolding them in the form of a ladder. Allows you to quickly view the card you want to use
• 2 additional compartments: one inside and one outside with a transparent plastic window for viewing the contents of the compartment

THINGS TO KEEP IN MIND

• The capacity of the card holder depends on the thickness and relief of the cards. It is estimated that it can hold up to 6 cards
• Leave the non-sublimatable part of the flap out of the plate. If this is not possible, cover it with heat seal tape, a piece of thick paper or cardboard to prevent it from getting dirty or damaged during printing
• Make sure the heat seal tape does not touch the leather of the wallet as you may tear it off when peeling it off

DIMENSIONS

RECOMMENDED INSTRUCTIONS AND PARAMETERS FOR SUBLIMATION PRINTING

Parameters are given as a guide only. It is recommended to make preliminary tests in order to make the necessary adjustments before starting production.

• Print the design in mode mirror
• Preheat the press to 200 °C
• Protect the non-sublimatable parts of the flap with paper and try to keep them out of the plate
• Place the wallet on the iron and the printed part of the paper on the wallet flap. Fix it with thermal adhesive tape
• Make sure that the adhesive heat tape does not touch the leather-like fabric of the wallet as this could be torn off when peeling it off
• Close the press with medium pressure for 40-45 seconds
• With the help of a protective glove, remove the newly printed wallet
• Carefully remove the paper from the flap