Plastisol Flock Adhesive

More information about the plastisol flock adhesive

INDEX

> Description

> Things to keep in mind

> Application parameters

> Instructions for use

> Container dimensions

> Data sheets

> Safety data sheets

DESCRIPTION

• Mix with 1-3% catalyst before coating the screen printing frame
• Very thick, viscous liquid. For bonding flock fibres to fabrics.
• Phthalate-free but does not reach the maximum ecological grade as it contains PVC
• Good wash fastness
• Manufactured in Turkey in cooperation with Brildor

THINGS TO KEEP IN MIND

• Stir well before use
• Do not thin with water
• Can be mixed with coloured plastisols in any ratio. This will create a coloured base which will give more opacity to the flock
• Also suitable for flock powder
• Storage temperature: 5-30ºC

APPLICATION PARAMETERS

Running tests is recommended to ensure the desired result.

INSTRUCTIONS FOR USE WITH FLOCK FILMS

• Spray temporary adhesive on the table of your screen printing machine and place the T-shirt
• Put the amount of adhesive you need in a bottle and add between 1% and 3% of the catalyst. Mix well
• Spread the mixture on the screen and apply using a squeegee
• Slowly lift the screen and dry the adhesive with the help of a flash dryer or heat gun
• Repeat these steps if you think it needs more adhesive and re-dry the adhesive
• Remove the T-shirt from the machine and place it on the press
• Cut out a piece of flock film and place it on the garment with the flocked side over the adhesive
• Cover with protective paper
• Press at 185 ºC for 50 seconds
• Cold peel the foil

Note: parameters tested with our Transflock films. We recommend testing for use with other flock films.

CONTAINER DIMENSIONS

DATA SHEETS

Data sheet plastisol flock adhesive (.pdf- 0.17 MB)

Data sheet catalyst (pdf - 0.16 MB)

SAFETY DATA SHEET

Safety data sheet plastisol flock adhesive (.pdf- 0.34 MB)

Safety data sheet catalyst (.pdf - 0,32 MB)