More information about the Screen Recovery Gel for Screen Printing Stargel 350

INDEX

> Description

> Things to keep in mind

> Usage instructions

> Storage recommendations

> Technical sheet

> Technical data

DESCRIPTION

• Ghost remover, eliminates embedded ink and emulsion residues. Restores the mesh for new uses
• Degreases and prepares the screen for applying a new emulsion with greater adhesion
• Gel texture that facilitates application on the screen
• Free from chlorine and harsh chemicals that could damage the mesh fabric

THINGS TO KEEP IN MIND

• Corrosive product. Always use with gloves and protective goggles in ventilated areas
• Do not allow the gel to dry on the screen to avoid fabric breakage

USAGE INSTRUCTIONS

• Clean and dry the screen beforehand
• Apply the gel on both sides of the screen using a brush or squeegee
• Let the product act according to the case indicated in the application and timing table
• Rinse with water, first at low pressure to remove the smell, then at high pressure to eliminate residues
• If any residue remains, perform a second application for 10 minutes following the same steps
• If possible, leave the screen in a tempered area between 22 ºC - 35 ºC

Information provided by the manufacturer for guidance purposes. It is recommended to conduct prior testing.

For screens with relief emulsion (thickened), recovery will always be 45 minutes to 1 hour.

STORAGE RECOMMENDATIONS

• Store in a cool, dry, and ventilated place
• Do not expose to temperatures below 8 ºC or above 35 ºC
• Sensitive to frost

TECHNICAL SHEET

Stargel 350 Gel (.pdf - 0.12MB)

TECHNICAL DATA