More information about Laser Transfer Paper - Multi-Trans Forever 

INDEX

> Description

> Recommended printers

> Tips and advice

> Application instructions

> Application parameters for each material

DESCRIPTION

• Can be applied to surfaces without polyester coating such as mugs, tiles, aluminium plates, untreated natural wood, glass, mirrors, ceramics...
• Extensive creative possibilities: designs with white toner, opaque prints on transparent backgrounds, metallic finish with foil, etc.
• Sales unit: pack of 10 A4 or A3 sheets, with a weight of 140 g/m²

RECOMMENDED PRINTERS

It is recommended to use a Uninet laser printer (Ref. 038196)

TIPS AND ADVICE

• The printable side is the opposite to the watermark side
• Use a silicone sheet to distribute the heat evenly across the entire surface (Ref. 011713)
• If applying to dark backgrounds, it is advisable to print the transfer paper with white toner to improve colour accuracy
• Temperature accuracy is important, so it is recommended to use a temperature indicator (Ref. 033374)
• If adhesive residue remains after application, you can clean it with isopropyl alcohol

APPLICATION INSTRUCTIONS

WITH MUG PRESS

• Print the design onto the transfer paper in mirror mode using the transparency or label option
• Place the design onto the mug and secure it with heat-resistant tape. We recommend covering it with a silicone sheet to distribute the heat evenly
• Open the press and insert the mug with the design
• Close and press at 140 ºC with high pressure for 180 seconds
  
• Open the press and cool the mug in a container with lukewarm water
• Peel off slowly but evenly

WITH HEAT PRESS

• Print the design onto the transfer paper in mirror mode using the transparency or label option
• Heat the press to 200 ºC
  
• Pre-heat the material if necessary
• Place the item to be printed on the press and the Multi-Trans paper on top. Secure it with heat-resistant tape
• Cover with a silicone sheet to ensure correct transfer
• Place the temperature indicator between the transfer paper and the surface of the material
• Close the press and when it reaches the temperature indicated in the table, open it and remove the paper as specified in the table below
• For some materials, a post-pressing is recommended. Place the printed item in the press and press again without fully closing the press

APPLICATION PARAMETERS FOR EACH MATERIAL

^(*) Needs to be preheated for 10 seconds before customising.

^(**) Needs to be preheated for 20 seconds before customising.