More information about the Sublimable MDF6 Basic Textured Photo Panels

INDEX

> Description

> Things to keep in mind

> Tips and advice

> Measurements

> Recommended sublimation instructions and parameters

DESCRIPTION

• White coating with a special rough texture for sublimation. By following the same procedure used for smooth surfaces, excellent results are achieved
• Rounded corners or edges
• Stand or support of 3 mm thickness, which can be slotted into any of the rear grooves to use the photo frame horizontally or vertically on flat surfaces

THINGS TO KEEP IN MIND

• The customisable side has a transparent plastic protective film that must be removed before customisation. The film on some photo panels includes an additional paper layer for extra surface protection. It is easily removed
• The wooden stand is separate, allowing you to customise the photo frame without obstacles
• Square-shaped ones can also be used as decorative tiles

TIPS AND ADVICE

• Attach hooks to the back to hang them on the wall. See Related Products
• Transform these photo frames into key or kitchen towel hangers, simply sublimate them and add hooks

MEASUREMENTS

RECOMMENDED SUBLIMATION INSTRUCTIONS AND PARAMETERS

Parameters indicated are for guidance only. It is recommended to conduct preliminary tests to make necessary adjustments before starting production.

• Print the design in mirror mode
• Heat the press to 200ºC
• Place the photo frame on the press base with the printed side of the paper on the photo frame
• Close the press with medium/high pressure for 70 seconds
• With the help of a protective glove, remove the freshly sublimated photo frame
• Carefully remove the paper