The store will not work correctly in the case when cookies are disabled.
The legal stuff about cookies:
This message requires us to tell you about our cookie policy. If you continue browsing, we'll assume you accept it and think it's okay.
Don't worry, this message only comes up once.
More information about sublimation fridge magnets from the geometric shapes collection
Decorative. Perfect for placing on magnetic surfaces such as refrigerators, metal boards, or as a souvenir.
Black-coloured edge and back.
Adhesive magnetic holder to fix on the magnet base after its personalisation.
Printable side protected by a transparent plastic film. It must be peeled off before sublimation.
Although it does not interfere with print quality, the edges may contain some residue from the laser cut and stain when touched. If this happens, it is recommended to clean the magnet with a damp cloth before its sublimation.
DIMENSIONS (APPROX.)
Reference nº
Shape
Magnet
Thickness
Print area
Magnetic holder
Thickness (holder)
039085
Round
Ø6 cm
3 mm
Ø6 cm
3 x 3 cm
1 mm
038299
Square
7 x 7 cm
3 mm
7 x 7 cm
3 x 3 cm
1 mm
039817
Square
10 x 10 cm
3 mm
10 x 10 cm
3 x 3 cm
1 mm
039084
Rectangular
6 x 8 cm
3 mm
6 x 8 cm
3 x 3 cm
1 mm
039818
Rectangular
10 x 15 cm
3 mm
10 x 15 cm
3 x 3 cm
1 mm
Recommended instructions and parameters for sublimation printing
Print the design in mirror image.
Preheat the press to 200ºC.
Remove the transparent protective film from the magnet.
Place the magnet on the press' lower plate and the paper's printed side against it. Fix with heat resistant tape.
Close the press at medium pressure for 40-45 seconds.
Using a protective glove, remove the newly printed magnet.
Remove the paper carefully.
Peel off the sticker from the magnetic holder and stick it on the back of the fridge magnet.