More information about the Sublimable MDF3 Wooden Decorative Pendants - Mickey and Minnie

INDEX

> Description

> Things to keep in mind

> Tips and advice

> Measurements

> Recommended sublimation instructions and parameters

DESCRIPTION

• Perfect for customising and turning into keyrings or decorative pendants
• Glossy white sublimable surfaces
• Rounded edges and corners with black borders
• Hole for attaching eyelets, rings, chains, cords, carabiners...
• Can also be customised with other techniques such as laser engraving, adhesive vinyl, UV DTF...

THINGS TO KEEP IN MIND

• The customisable surfaces have a protective transparent plastic film that must be removed before sublimation. Some keyrings have an additional paper layer for further surface protection. They can be easily removed
• Due to the position of the hole, these pendants are not compatible with the plastic closure ring (Ref. 037834)

TIPS AND ADVICE

Create a variety of products with this customisable pendant:

• Keyrings: attach rings with link or ball chains
• Decorative pendants: tie a cord, ribbon, jute thread...
• Tags: add a loop strap to hang on backpacks, suitcases, travel bags, cases...

MEASUREMENTS

RECOMMENDED SUBLIMATION INSTRUCTIONS AND PARAMETERS

Parameters are indicative. It is recommended to conduct preliminary tests to make necessary adjustments before starting production.

• Print the design in mirror mode
• Heat the press to 180 ºC
• Remove the transparent plastic film covering the pendant's surface
• Place the pendant on the press base and the printed side of the paper on the pendant. Secure them with thermal adhesive tape
• Close the press with medium pressure for 60 seconds
• Using a protective glove, remove the freshly printed pendant
• Carefully remove the paper
• If you wish to sublimate the other side of the pendant, repeat the previous steps
• Attach the desired eyelet and ring