More information about the Rhinestone Transfer Starter Kit

INDEX

> Description

> Things to keep in mind

> What does the kit include?

> Instructions for use

DESCRIPTION

• Ideal kit for those who want to start customising textiles with rhinestones, as well as rigid surfaces
• Allows you to prepare transfers with any type of heat-adhesive rhinestones, regardless of size and model: strass, crystals, studs...
• Easy to use: prepare the design template using vinyl, fill it with stones, and then adhere them to a carrier that will allow you to transfer it to the application surface. The tools included in the kit make this task easier
• Once the rhinestone transfers with the desired design are created, they can be applied immediately with a transfer press or left prepared for later application
• You can purchase the tools and materials separately, without needing to buy the entire kit

THINGS TO KEEP IN MIND

• A cutting plotter is required for preparing the design template
• The kit of materials and tools includes a cutting mat suitable for plotters with a minimum width of 33 cm
• The template can be reused to create more than one transfer of the same design. To prevent damage, after use, replace the vinyl liner or adhere the template to a board, an acrylic sheet, or something similar

WHAT DOES THE KIT INCLUDE?

INSTRUCTIONS FOR USE

• Create the template design and print it with a cutting plotter
• Print using the flocked vinyl along with the cutting mat, adhere the vinyl on the adhesive side back onto the cutting mat
• Remove excess material from the template with the help of the awl or tweezers
• Pour the rhinestones over the template and use the brush to spread them into the design holes until fully covered
• Place the adhesive side of the carrier paper over the stones to create your transfer
• Finish by storing the template, protecting it with the back of the carrier paper or fixing it on the product