More information about the sublimation football socks and their jigs

INDEX

> Description

> Dimensions

> Recommended instructions and parameters for sublimation printing

DESCRIPTION

• Socks or socks for football or other sporting activities
• Elasticated bands on the upper edge of the shaft, ankle and instep to adapt them to the foot
• Highly breathable fabric reinforced at the instep for extra comfort
• Wooden last with rounded edges. Used as a mould or insole to facilitate the entire customisation process
• Some lasts have an additional layer of paper to protect their surface. Easily removable

DIMENSIONS

*Only the area of the leg without elastics is indicated, although the stockings can be fully sublimated.

RECOMMENDED INSTRUCTIONS AND PARAMETERS FOR SUBLIMATION PRINTING

Parameters are given for guidance only. It is recommended to carry out preliminary tests in order to make the necessary adjustments before starting production.

• Print the design in mirror image
• Preheat the press to 200ºC
• Insert a jig into each sock avoiding wrinkles.
• Place the socks on the printed side of the paper and fix them with heat-resistant tape.
• Put protective paper on the base of the press and lay the socks on it.
• Cover the socks with protective paper
• Press for 40 seconds, medium pressure
• Remove the newly printed sock using a protective glove
• Carefully lift off the paper and let it cool down a little bit
• Pull the edge of the sock upwards so that the white trim is not visible when printing on the other side
• Repeat the same process to sublimate the remaining side
• Take the jigs out of the socks while hot and let them cool down