More information about the Sublimation FRP Plastic Name Badges

INDEX

> Description

> Things to keep in mind

> Things to keep in mind

> Dimensions

> Customisation Templates

> Recommended Sublimation Instructions and Parameters

DESCRIPTION

• White plastic reinforced with fibreglass (FRP)
• Available in oval or square shape with rounded corners
• Customise the badge with an ID, photo, original message, or for use as a corporate gift or promotional item

ACCESSORIES FOR ATTACHING TO BADGES

SAFETY PINS

• Metal pin that attaches to the garment
• Secure closure to prevent the pin from opening
• Flat plastic base of 37 mm with adhesive for attaching to the badge
• More sizes available in Related Products

MAGNETS

• Secure attachment of the badge to the garment
• Prevents damage to the fabric
• Plastic base with 2 or 3 neodymium magnets. Placed inside the garment to hold the badge
• Metal plate with adhesive for attaching to the badge

THINGS TO KEEP IN MIND

• Do not include a transparent protective plastic film on the customisable side
• Sublimate on the non-textured side, where the fibreglass is not visible
• The safety pin or magnet should be attached to the back of the badge after sublimation

DIMENSIONS

CUSTOMISATION TEMPLATES

• Name badge 32 x 76 mm (.eps - 79Kb)
• Name badge 36 x 76 mm (.eps - 75Kb)
• Name badge 51 x 76 mm (.eps - 79Kb)
• Oval name badge 38 x 76 mm (.eps - 79Kb)

RECOMMENDED SUBLIMATION INSTRUCTIONS AND PARAMETERS

Parameters provided for guidance purposes. It is recommended to conduct preliminary tests to make necessary adjustments before starting production.

• Print the design in mirror mode
• Heat the press to 200 ºC
• Place the badge on the press base and the printed side of the paper on the badge
• Close the press with medium pressure for 60 seconds
• Use a protective glove to remove the freshly printed badge
• Carefully remove the paper
• Attach the safety pin or magnet to the back of the badge