The store will not work correctly in the case when cookies are disabled.
The legal stuff about cookies:
This message requires us to tell you about our cookie policy. If you continue browsing, we'll assume you accept it and think it's okay.
Don't worry, this message only comes up once.
A "Baby on Board" sign you can personalise using dye sublimation printing. A fun and original way of warning drivers that there are kids inside the car.
Made of medium-density fibreboard (MDF). Square-shaped, white-coloured and with gloss finish.
More information about the "Baby on Board" sign for sublimation
Especially useful to warn about the presence of children, pregnant women, or pets inside the car.
This wooden sign of multiple uses is also known as MDF (medium-density fibreboard).
Matte black edges and back.
Rounded corners with 2 holes to place the suction cups.
White printable side covered with a clear protective sheet that must be peeled off before sublimation.
THINGS TO KEEP IN MIND
Although it does not interfere with print quality, the edges may contain some residue from the laser cut and stain when touched. If this happens, it is recommended to clean the sign with a damp cloth before its sublimation.
Recommended instructions and parameters for sublimation printing
Print the design in mirror image.
Preheat the press to 180-200 ºC
Remove the clear protective plastic from the sign's printable side.
Place the sign on the press between two protective papers and pre-press it for 10 seconds. This will remove any moisture the wood may have absorbed.
Place the sign back on the press' lower plate with its printable side facing up and the paper's printed side against it. Fix them with heat-resistant tape.
Close the press at medium pressure for 80-85 seconds
Using a protective glove, remove the newly printed sign.
Remove the paper carefully.
Place the suction cups in the holes so that the sign is ready to use.