€39.90 VAT not included / Each Unit

Cricut Engraving Tip + QuickSwap™ Housing

Ref.
039097

Cricut Engraving Tool with Quick Swap™ housing for use with the Cricut Maker vinyl cutter.

  • Perfect for personalisation with monograms, texts, figures or embellishments.
  • You may use this housing with other tips compatible with this vinyl cutter.
  • Engrave a wide range of materials such as anodised aluminium, leather, faux leather, plastic, and many more.

More information

Availability:
Immediate: 4 units
Our availability is not enough?
Let us know how much you need
Request Notice
€39.90 VAT not included / Each Unit
VAT not included
Reward Points
As a Premium Brildor Member, for each unit you buy, you will accumulate {{POINTS}} to redeem on your next order. Discover the Brildor Loyalty Program. For each unit you buy, you will accumulate {{POINTS}} to redeem on your next order. Discover the Brildor Loyalty Program.

More information about the Cricut Engraving Tip with QuickSwap™ Housing

  • The tip marked with the number 41 is only compatible with Cricut Maker vinyl cutters, and can only be used with this tool holder.
  • No calibration required.
  • Make sure you choose the right cutting mat for the material you want to engrave.
  • The engraving function is available on Design Space® iOS and Android versions.

HOW TO CHANGE QUICKSWAP TIPS?

  • Press and hold the plunger on top of the housing until the tip is released.
  • Gently remove the tip from the tool holder.
  • While pressing the plunger, align flat areas on the new tip with the housing's flat sides.
  • Slide the tip into place.
  • Ensure the tip is firmly clamped.
  • Release the plunger to secure the tip.
  • Drop the housing into clamp “B”.

RECOMMENDATIONS

  • Do not press on the plunger to prevent the tip from coming out.
  • The engraving tip is sharp and must be handled carefully.
  • To minimise wear on the tip when engraving, the housing will be raised and rotate for a few seconds at regular intervals.
  • Be careful when handling engraved materials. Small fragments of the material may have come off. You can remove them with a lint roller or with a piece of adhesive tape.
  • If you observe irregularities on the edges after engraving, remove them with a polishing cloth or sandpaper (360-600 grit). We recommend you to try this on the back of the material beforehand, to make sure that it will not be scratched by this procedure.
  • Use compressed air or a soft cloth to remove any engraving residue that may have fallen into the vinyl cutter. Always wipe towards the outside of the machine.
  • Before engraving leather, smooth its surface with a dry sponge. This will soften its fibres, giving you better results.

More Information
Ref. 039097
EAN 093573039324
Gross Weight (kg) 0.04
Billable Weight (kg) 0.0500
Post your question